XIHE Capsule product archive visual.
Solution · By Application
Heating inside enclosed wellness cabins, where dual-zone panels, surface uniformity and electrical distribution are engineered as one system.
Buyer question
Heating component
Review the component construction, available supply formats and integration requirements.
Next decision
Enclose the heating function without losing inspectability or control.
Validation evidence
Translate the requirement into a sample, method, conditions and acceptance decision.
01 · The challenge
The constraint is the product around the heat source, not the heat source alone.
Upper and lower zones face different surfaces, heat-loss paths and occupant-contact conditions.
Contact-facing surface temperature must stay inside a defined, controllable range for the whole session.
Wiring, branch loading and connector temperature interact inside a sealed enclosure.
02 · Design approach
The film is designed as part of the product build — layer by layer, with the electrical and mechanical constraints stated up front.
Engineer the upper cabin and lower mattress as two coordinated thermal interfaces inside one enclosure. The existing capsule configuration gives an OEM program a concrete starting point for zone geometry, controls and service access.
03 · Engineering parameters
Agree these inputs before selecting a film configuration or requesting a sample.
| Design input | What to establish |
|---|---|
| Enclosure geometry | Internal volume, upper and lower panel areas and facing materials. |
| Zone definition | Power allocation, control independence and target surface range per zone. |
| Electrical distribution | Input supply, branch loading, connectors and protective response. |
| Service conditions | Cleaning, replaceable facing materials and reassembly checks. |
XIHE supplies the heating subsystem, not a medical device. Far-infrared emission is a measured material-level property of the film under stated test conditions; no therapeutic, treatment or physiological outcome is stated on this site.
04 · Validation
Map each defined zone surface with external reference probes under agreed operating conditions. Record branch current, voltage drop and connector temperature during representative sessions.
Define the sample identity, fixture, operating conditions and acceptance criteria, then review the applicable records in the Engineering evidence centre.
Application scenarios
Compare the product structures, integration constraints and validation questions relevant to your design.
Review the existing dual-zone configuration: upper cabin and lower mattress as two thermal interfaces.
Review the integration record →04 · Relevant case studies
Explore existing product integrations and engineering assessments. Each record identifies the product context, design decisions and validation scope.
Manufacturing handoff
Release only the identified configuration, evidence and acceptance criteria needed for the next build stage.
The full prototype, pilot and repeat-production control sequence belongs to the Manufacturing owner. This page defines the requirement and the evidence that must accompany the handoff.
Describe the product, the heating area and the electrical constraints. We will review the heating architecture with you.
Start Technical Review